Discovery 1 Bumper Light Guard Set
Rear Light Guards for the bumper lights on the Land Rover Discovery 1.
Made from thick laser cut and bent steel for strength and rigidity, and powder coated in a matt black finish for corrosion protection and a high class look. These guards will protect the vulnerable rear lights while still allowing you to change bulbs and do maintenance from behind. Price is for a set (1x left and 1x right hand side).
Actual product may vary to images due to product enhancement.
Fitting instructions:
- Loosen the rear corner bumperettes by loosening the 2x M8 bolts on the inside of the bumperette. Slide the bumperette to the side to give space.
- Mark and drill 4x holes with an M5 drill bit to match the holes in the light protector.
- Mask off the area, and spray some paint in the newly drilled holes to protect from corrosion on the bumper.
- Pop rivet the guards into place.
- Slide the bumperettes back into their original place and tighten the bolts.
- Some models of Discovery may require you to trim the plastic bumperettes slightly with a Stanley knife to allow the bumperettes to slide over the guards for a tighter, snug fit.
Additional information
| Weight | 1 kg |
|---|---|
| Dimensions | 25 × 9 × 4 cm |
Orders and Delivery:
Your delivery fee will show on the check-out page. We use the shipping address to determine the fee.
We do our best to keep this accessory in stock because a fabrication lead time applies if it is sold out (max. 3 weeks). So, if you need it urgently, we would like you to get in touch with us before finalizing your order.
Prefer to pick-up? We will gladly assist!
Discovery 1 Bumper Light Guard Set
R585.00
Available on backorder
Rear Light Guards for the bumper lights on the Land Rover Discovery 1.
Made from thick laser cut and bent steel for strength and rigidity, and powder coated in a matt black finish for corrosion protection and a high class look. These guards will protect the vulnerable rear lights while still allowing you to change bulbs and do maintenance from behind. Price is for a set (1x left and 1x right hand side).
Actual product may vary to images due to product enhancement.
Fitting instructions:
- Loosen the rear corner bumperettes by loosening the 2x M8 bolts on the inside of the bumperette. Slide the bumperette to the side to give space.
- Mark and drill 4x holes with an M5 drill bit to match the holes in the light protector.
- Mask off the area, and spray some paint in the newly drilled holes to protect from corrosion on the bumper.
- Pop rivet the guards into place.
- Slide the bumperettes back into their original place and tighten the bolts.
- Some models of Discovery may require you to trim the plastic bumperettes slightly with a Stanley knife to allow the bumperettes to slide over the guards for a tighter, snug fit.
